Huawei SUN2000-3KTL-L1 User Manual

C Resetting Password
Step 1 Ensure that the SUN2000 connects to the AC and DC power supplies at the same
time. Indicators
and are steady green or blink at long intervals for more than
3 minutes.
Step 2 Perform the following operations within 4 minutes:
1. Turn o the AC switch and set the DC switch at the bottom of the SUN2000
to OFF. If the SUN2000 connects to batteries, turn
o the battery switch. Wait
until all the LED indicators on the SUN2000 panel turn o.
2. Turn on the AC switch, set the DC switch to ON, and wait for about 90s.
Ensure that the indicator is blinking green slowly.
3. Turn o the AC switch and set the DC switch to OFF. Wait until all LED
indicators on the SUN2000 panel are
o.
4. Turn on the AC switch and set the DC switch to ON. Wait until all indicators
on the solar inverter panel blink and turn
o 30 seconds later.
Step 3 Reset the password within 10 minutes. (If no operation is performed within 10
minutes, all inverter parameters remain unchanged.)
1. Wait until the indicator
blinks green at long intervals.
2. Obtain the initial WLAN hotspot name (SSID) and initial password (PSW)
from the label on the side of the SUN2000 and connect to the App.
3. On the login screen, set a new login password and log in to the App.
SUN2000-(2KTL-6KTL)-L1
User Manual C Resetting Password
Issue 10 (2023-02-13) Copyright © Huawei Technologies Co., Ltd. 119

Huawei SUN2000-3KTL-L1 Specifications

General

Max. efficiency	98.4%
Max. input voltage	600 V
Nominal output power	3000 W
Dimensions (W x H x D)	365 x 365 x 156 mm
Operating temperature range	-25°C to +60°C
Nominal AC voltage	220 V / 230 V / 240 V
MPPT voltage range	90 V - 560 V
Rated input voltage	360 V
Number of MPPTs	2
Cooling	Natural Convection
Protection degree	IP65
Rated output voltage	220 V / 230 V / 240 V
Output frequency	50 Hz / 60 Hz
Power factor	0.8 leading ... 0.8 lagging
THDi	<3%
Efficiency	98.4%
Warranty	10 years
Max. apparent AC power	3300 VA
Max. output power	3300 W