Huawei SUN2000-3KTL-L1 User Manual

3 SUN2000 Storage
The following requirements should be met if the SUN2000 is not put into use
directly:
● Do not unpack the SUN2000.
● Keep the storage temperature at –40°C to +70°C and the humidity at 5%–
95% RH.
● The product should be stored in a clean and dry place and be protected from
dust and water vapor corrosion.
● A maximum of eight SUN2000s can be stacked. To avoid personal injury or
device damage, stack SUN2000s with caution to prevent them from falling
over.
● During the storage period, check the SUN2000 periodically. (It is
recommended that the check is performed every three months.) Replace the
packing materials that are damaged by insects or rodents in a timely manner.
● If the SUN2000 has been stored for more than two years, it must be checked
and tested by professionals before being put into use.
SUN2000-(2KTL-6KTL)-L1
User Manual 3 SUN2000 Storage
Issue 10 (2023-02-13) Copyright © Huawei Technologies Co., Ltd. 23

Huawei SUN2000-3KTL-L1 Specifications

General

Max. efficiency	98.4%
Max. input voltage	600 V
Nominal output power	3000 W
Dimensions (W x H x D)	365 x 365 x 156 mm
Operating temperature range	-25°C to +60°C
Nominal AC voltage	220 V / 230 V / 240 V
MPPT voltage range	90 V - 560 V
Rated input voltage	360 V
Number of MPPTs	2
Cooling	Natural Convection
Protection degree	IP65
Rated output voltage	220 V / 230 V / 240 V
Output frequency	50 Hz / 60 Hz
Power factor	0.8 leading ... 0.8 lagging
THDi	<3%
Efficiency	98.4%
Warranty	10 years
Max. apparent AC power	3300 VA
Max. output power	3300 W