Instrumentation and Controls
. . . 102
High-Low Beam Control
When the headlights are turned on
and the lever is in the center posi-
tion, the headlights are set to low
beams.
Push the lever toward the front of
the vehicle to turn on the high
beams.
Pull the lever back to the center
position to return to low beams.
When the high beams are on, an
indicator light on the instrument
cluster will also be on.
You may be able to flash your high
beams to signal other drivers.
To do this, pull the multifunction
lever toward you.
Then release the lever.
If the headlights are in the auto-
matic mode or on low beam, the
high-beam headlights will turn on.
The high beams will stay on as
long as you hold the lever.
Cruise Control
CAUTION
Don't leave your cruise control
switch on when you're not
using it.
If you accidentally activate
cruise control, you could be
startled and even lose control of
the vehicle.
04AKENG59_H3T.fm Page 102 Thursday, July 31, 2008 12:07 PM
To Next Page
Loading...
Need help?
General
