361 . . .
–
–
–
–
–
Section 5
8. Disconnect the wrench from
the jack and carefully remove
the jack.
Use one hand to push against
the spare while firmly pulling
the jack out from under the
spare tire with the other hand.
9. When the tire has been com-
pletely lowered, tilt the
retainer at the end of the
cable and pull it through the
wheel opening.
10. If the cable is hanging under
the vehicle, turn the wheel
wrench clockwise to raise the
cable back up.
Have the hoist assembly inspected
as soon as possible. A spare or flat
tire cannot be stored using the
hoist assembly until the hoist
assembly has been repaired or
replaced.
Spare Tire
The spare tire is attached to the
tire carrier underneath the vehicle.
Although the spare tire was fully
inflated when your vehicle was
new, it can lose air after a time.
Check the inflation pressure
regularly.
See the tire information label for
the proper tire inflation
specifications.
To determine the location of your
vehicle’s tire information label, see
"Vehicle Loading" in Section 3.
After installing the spare tire on
your vehicle, stop as soon as
possible to make sure the tire is
correctly inflated.
04AKENG59_H3T.fm Page 361 Thursday, July 31, 2008 12:07 PM
To Next Page
Loading...
Need help?
General
