Starting and Operating Instructions
. . . 198
PROGRAMMING ADDITIONAL
KEYS
You can program up to eight addi-
tional keys with the two original
keys present. To program an addi-
tional key:
1. Verify that the new key has
PK3+ stamped on it.
2. Start the engine using one of
the previously programmed
keys.
If the engine does not start,
see your dealer for service.
3. Turn off the ignition and
remove the key.
4. Within ten seconds of turning
off the ignition, insert the
other previously programmed
key and start the engine.
If the engine does not start,
see your dealer for service.
5. Turn off the ignition and
remove the key.
6. Within 10 seconds of turning
off the ignition, insert the key
that you are programming
and start the engine.
Once the key is programmed,
the Security System Light will
turn off.
If additional keys are to be
programmed, repeat the
previous steps.
If you have only one key that oper-
ates the vehicle, contact your deal-
er to program additional keys.
04AKENG59_H3T.fm Page 198 Thursday, July 31, 2008 12:07 PM
To Next Page
Loading...
Need help?
General
