INSTALLATION
12
Spacer Blocks (Optional)
Spacer blocks can be used to add clearance. Two versions are available:
1
⁄
2
" and
7
⁄
8
".
Attach the installation brackets to the spacer blocks using the two screws provided with
each spacer block.
Then attach the spacer blocks to the mounting surface with screws through the two holes
in the rear of the spacer blocks.
Use a level to check that the tops of the spacer blocks are aligned at the same height
before tightening the screws.
Proceed to “Install the Blind” on page 14.
Spacer
Block
Flat Top of
Spacer Block
Hidden
Installation
Bracket
Beveled Box
Installation
Bracket
Spacer Blocks with Hidden Installation Bracket
Spacer Blocks with Beveled Box Installation Bracket
To Next Page
Loading...
Need help?
General
