OPERATION
16
Using the PowerView
®
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the PowerView Motorization Remote Control Guide.
Joining a Shade or Shading to a Group
IMPORTANT: A window covering will not operate using the remote until it has been joined to
a group. If both the rear shade and front shading must be joined to a group, it is recommended
that they be in different groups for individual operation, as well as in the same group for
simultaneous operation. (Note that any window covering can belong to more than one group.)
Both window coverings will also operate simultaneously if both individual group buttons are
selected, or the “all” button is selected.
1. Press and hold ■ STOP on the remote until the indicator lights blink (approximately
6 seconds). The remote is now in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlit group number will flash to
show it is selected.
3. While pressing the programming button on the shade or shading, press ▲ OPEN on the
remote. The green light flashes once and either the shade or shading will move slightly twice
(up, down, or down, up) to indicate the shade or shading has joined the group. Release the
programming button.
4. Press and hold ■ STOP on the remote until the indicator lights stop blinking (approximately
6 seconds).
Group 1
Group 2
CLOSE
Group 3
Group 5
Group 6
Favorite
(Shade and/or shading position)
ARROW
Opens vanes on front
shading; no function
for rear shade
RIGHT ARROW
Opens vanes on front shading;
no function for rear shade
STOP
(Press and hold for
To Next Page
Loading...
Need help?
General
