Hunter G835 - Stator Adjustments - G80 Risers

STAToR AdjuSTMenTS
–
g80 RiSeRS
Turn the riser upside down, remove the lter screen and view the stator area. Notice the black part with the three
sections extending outward from the center (g 60). This black part on G80 risers is called the adjustable stator plate.
Beneath the adjustable stator plate is a gray non-removable part with the three openings. This part is called the stator.
The stator has a series of numbers engraved into the plastic. These numbers are the nozzle size reference numbers.
To make an adjustment, rotate the adjustable stator plate to the right in a clock-wise direction (g 61). Notice the
small cutout or “window” on the adjustable stator plate. As the adjustable stator plate is rotated, the various nozzle
reference numbers will appear in the cutout/window. Simply keep rotating the adjustable stator plate until the
desired nozzle number on the gray stator appears in the cutout/window. Double-check to make sure the desired
nozzle number is visible in the cutout/ window. Finally, install the lter screen as outlined in the lter screen servicing
section above.
FIG 60 FIG 61



Fig 60
Fig 61



Fig 60
Fig 61
22