Hunter G835 - Solenoid & Pilot Valve Assembly Removal

Solenoid & PiloT VAlVe ASSeMbly ReMoVAl
In order to work on the Solenoid or the Pilot Valve, it is rst necessary to remove the connected Solenoid and Pilot
Valveassemblyfromtheangecompartment.Priortoremoval,takenoteoftheorientationofthettingsandtubing
that are attached to the Pilot Valve. This will help with nal assembly later.
ToremovetheSolenoidandPilotValvefromtheangecompartment,grabtheSolenoidandwiggleitbackandforth
whileliftingupwards(g130).PulltheSolenoidandPilotValveassemblyupandontopoftherotor’sange(g131).
FIG 130 FIG 131



Fig 129
Fig 130



Fig 129
Fig 130
43