Hunter G835 - Stator Adjustments

STAToR AdjuSTMenTS
–
WHy And WHen ARe THey needed?
The adjustable stator is preset at the factory to match the nozzle installed in the rotor. The purpose of the stator is to
maintain a consistent and desirable speed of rotation. Rotors that turn too fast cannot reach their published radius
distance. Rotors that turn too slow will irrigate with a higher precipitation rate per revolution causing wet spots and run-off.
Ifnozzlesarechangedtoaowgreaterthantheoriginalfactorynozzle,thespeedofrotationwillbecomefaster
unless the appropriate stator adjustments are made. This is because there is a greater amount of water passing the
turbinethatdrivesthegearbox.Theoppositeistrueifasmallerownozzleisinstalledwithoutadjustingthestator-
the rotor will slow down. In extreme situations, the rotor may not rotate at all if the stator is not adjusted. Again, stator
adjustmentsarenotrequiredunlessthenozzleowisbeingchangedor,thestatorwassetincorrectlyatsomepoint
in time.
Setting the stator is as simple as matching the stator setting number to the nozzle number being used in the rotor.
For example, if the nozzle in use is #20, then the stator setting will be #20. To access the stator adjustment, rst
remove the riser’s lter screen as outlined in the section above.
STAToR AdjuSTMenTS
–
g35, g70 & g75 RiSeRS
Turn the riser upside down, remove the lter screen and view the stator area. Notice the black part with the three
sections extending outward from the center (g 57). This black part on G70 and G75 risers is called the adjustable
stator plate. Beneath the adjustable stator plate is a gray non-removable part with the three openings. This part is
called the stator. The stator has a series of numbers engraved into the plastic. These numbers are the nozzle size
reference numbers.
To make an adjustment, use the blade end of the snap-ring tool or a bladed screwdriver to lift the adjustable stator
plate off the stator. To do so, place the tool under one of the two tabs on the post at the center of the stator (g 58).
Pry the tab upward and the stator plate will snap off.
To reset and install the adjustable stator plate, notice the small cutout on each of the three sections of the adjustable
stator plate. Next, on the stator nd the nozzle number that is being used. Simply align any one of the cutouts on the
adjustable stator plate with the desired nozzle number on the gray stator (g 59). Then, snap the adjustable stator
plate down into position. Once the stator plate is installed, check to make sure the desired nozzle number is visible in
the cutout window. Finally, install the lter screen as outlined above.
FIG 57 FIG 58 FIG 59




Fig 57
Fig 58
Fig 59




Fig 57
Fig 58
Fig 59




Fig 57
Fig 58
Fig 59
21