Maintenance
14.3
cleaning and polishing products.
14.2.3.2 Recommended Procedures
DO…Apply an even layer of the polishing compound
onto a clean soft rag and distribute over a manage-
able area of the stainless surface with a soft rotational
motion.
DO…Repeat the application if some surface stains
remain until all the finish is back to the original clean
shiny finish.
DO…Remove any excess polishing compound and
polish out the stainless finish for a mirror shine.
DO...Rinse thoroughly with fresh water after each
cruise. Thorough rinsing can prevent a lot of the sur-
face staining that stainless steel experiences when left
in contact with salt water residue.
DO...Dry after each use to prevent mineral deposits
from building up on the surface of the finish.
DO NOT...Scour the stainless. Scouring can damage
the original finish.
DO...Be careful using most brands of cleansers. Often
they contain chemical additives which will affect the
original high polish finish if left on the stainless.
DO NOT...Use a steel wool pad to clean your stainless.
If a more abrasive product is needed, use a stainless
polishing paste being sure to rub in the paste with a
clean rag. Steel wool pads have a tendency to break
apart and small particles of steel can become embed-
ded in the surface and will rust and will give the appear-
ance that the stainless itself is rusting.
14.2.3.3 Chlorides
Today, chlorides are found in almost all soaps, deter-
gents, bleaches and cleansers; chlorides can be aggres-
sive to stainless steel. However, chlorides are very water
soluble. Therefore, THOROUGH RINSING of your bright
work after each use will help to keep your stainless look-
ing bright and shiny.
14.2.2.4 Scratches
Like many metallic surfaces, your stainless steel will
scratch. These are merely usage scratches and over time
will blend into the overall finish. Surface scratches can
be polished out with a polishing paste but this can be a
•
•
•
•
•
•
•
•
lengthy and work intensive process.
14.2.4 Deck Hatches
14.2.4.1 Gaskets
Wax the rubber gaskets on all deck hatches with a car-
nauba wax to ensure gasket material does not stick to
Plexiglass.
14.2.4.2 Acrylic and Plexiglass
DO NOT use glass cleaning sprays, scouring com-
pounds, or solvents (such as acetone, gasoline, or thin-
ners) to clean acrylic or Plexiglass.
Following are guidelines for cleaning acrylic and Plexiglass
parts:
Wash acrylic hatches, windows, and any other acrylic
compounds with mild soap and plenty of lukewarm
water.
Use a clean, soft cloth.
Apply only a light pressure when cleaning.
Rinse with clear water, and blot dry with a damp cloth
or chamois.
14.2.5 Windows
14.2.5.1 Port Lights
See the Acrylics and Plexiglass section above.
14.2.5.1.1 Frames
The port light window frames on your boat are made of
high quality aluminum with an enamel paint or anodized
surface. The frames need no maintenance other than
cleaning with soap and water. Do not use abrasive or
strong chemicals. These may damage the finish and
allow corrosion to start. Frames should be protected with
marine wax.
14.2.6 Caulking
All deck fitting, bow rails, hatches, etc, have been caulked
with the highest quality material to ensure a waterproof
joint with the boat. However, normal use will flex the joint
and eventually break down the seal.
•
•
•
•
To Next Page
Loading...
