Maintenance
14.8
After re-connecting the terminals, apply a coating of
grease or petroleum jelly (Vaseline) to protect them
against corrosion.
IMPORTANT: Before cleaning the batteries, disconnect and
remove them from the boat.
Replace corroded or damaged parts immediately.
Remove the batteries from the boat during periods of
extended storage. Store the batteries in a cool (above
freezing), dry area.
All batteries lose some charge during storage, but the
loss of charge is proportional to the temperature. The
lower the temperature, the less charge is lost. Avoid
storing the batteries in a humid area. Humidity will lead
to corrosion of the terminals.
14.4.7 Shore Power Cable Care
Electrical shock can cause injury or death. Before
working on electrical system, disconnect all power
sources. Inform others to prevent accidental re-
connection of electrical service. All voltages above
12 volts are dangerous. Performing maintenance
while connected to shore power can cause electrical
shock. Disconnect cord before performing mainte-
nance.
Clean the cable with a grease cutting household deter-
gent. Apply a vinyl protector periodically.
The metallic parts of the cable are corrosion resistant.
You can, however, increase the life of the cable in a salt
water environment by wiping the exposed parts with fresh
water. Then, dry them and spray them with a moisture
repellent.
If the cable is dropped into salt water, rinse the plug and
connector end thoroughly in fresh water. Then shake or
blow off excess water and allow cable to dry. Spray plug
and connector with a moisture repellent before you use
the cable again.
14.4.8 Windlass Maintenance
Periodically check the motor and control box electrical
connections. Remove any residue and cover connec-
tions with a small coating of grease.
•
•
•
It is recommended that you annually disassemble the
windlass and remove any residue buildup. To perform
this maintenance follow all safety procedures and com-
plete the instructions listed in the windlass OEM manual.
Using the emergency handle, unscrew and remove
the clutch nut and gypsy cone.
Unscrew and remove the stripper arm. Pull control
are back to clear gypsy and remove gypsy assembly
from the drive shaft.
Wash down with water to remove any residue.
Coat surfaces with a light film of lubricant.
Reassemble the unit and tighten the clutch by turning
the handle clockwise.
NOTE: Consult the windlass manufacturer’s OEM
manual for further details regarding operation, care and
maintenance.
Ensure power is off before performing work or
maintenance on the windlass.
14.4.9 Electrical System Connections
At least once each year, disconnect electrical connectors
in the bilge, engine, and upper control panels. Check the
terminals for corrosive buildup. Have your dealer repair
connectors and terminals if they are corroded.
14.5 Periodic Maintenance
Proper and timely maintenance is the best insurance for
trouble free and enjoyable boating. Please refer to the
maintenance charts located in the back of this chapter to
help identify maintenance tasks and their frequency. Use
the charts as a checklist.
Remember to check your OEM manuals to understand
the recommended periodic maintenance and procedures
for their products. OEM period maintenance guidelines
will take precedence over the minimum guidelines sug-
gested in this manual.
1.
2.
3.
4.
5.
To Next Page
