Easy Retrieve Program Memory
The X-Core is capable of saving the preferred watering program
into memory for retrieval at a later time. This feature allows for a
quick way of resetting the controller to the original programmed
watering schedule.
To save the program into the memory
1. With the dial in the RUN position, press and hold the
and
buttons for 5 seconds. The display will scroll three segments
from le to right across the display indicating the program is
being saved into memory.
2. Release the and buttons.
To retrieve a program that was previously saved into memory.
1. With the dial in the RUN position, press and hold the and
buttons for 5 seconds. The display will scroll three segments
from right to le across the display indicating the program is
being saved into memory.
2. Release the and buttons.
Programmable Delay Between Stations
This feature allows the user to insert a delay between stations when
one station turns o and the next one turns on.
1. Start with the dial in the RUN position.
2. Press and hold the
button down while turning the dial to the
RUN TIMES position.
3. Release the button. At this point the display will show a delay
time for all stations in seconds, which will be ashing.
4. Press the or buttons to increase or decrease the delay time
between 0 seconds to 4 hours.
5. Return the dial to the RUN position.
Resetting Controller / Clearing Controllers Memory
If you feel you have misprogrammed the controller, there is a
process that will reset the memory to the factory defaults and erase
all programs and data that have been entered into the controller.
1. Press and hold the
button.
2. While holding the button, press and release button on the
right - hand side of the controller.
3. Continue holding button until time 12:00 am is displayed (this
takes about 8 seconds).
ADVANCED FEATURES
Reset
26
To Next Page
Loading...
Need help?
General
