CLIK DELAY INSTRUCTIONS
Clik Delay Feature
This feature allows the user to delay programmed waterings for a
designated period (from 1-7 days) AFTER a Clik Event ends. At the
end of the Programmed Clik Delay period, the controller will resume
normal automatic irrigation.
1. Turn the dial to the RUN Position
2. Press and hold the
button for 3 seconds, then turn the
dial to the OFF position
3. Release the button. The display will show the program-
mable Clik Delay.
4. Press the
button to set Clik Delay duration (from 1 to 7 days).
5. Return the dial to the RUN position. Clik Delay is set.
Aer a Clik Event ends (rain sensor changes from wet to dry) the
Clik Delay feature will become active and the screen will display Clik
Delay duration. The day countdown will occur 24 hours aer the
start of Clik Delay.
An active Clik Delay can be cancelled by turning the dial to the OFF
position, waiting for OFF to stop ashing, then turning the dial back
to the RUN position.
Any station that is set to override sensor, as well as Lighting
Programs, will operate during a Clik Delay event.
NOTE: Use caution when using the
programmable Clik Delay feature with Hunter
Wind-Clik, Freeze-Clik, Soil- Clik, and freeze
component of Solar Sync and Rain/Freeze Clik as
the Clik Delay will become active AFTER Clik Event
from these devices.
SENSOR DAYS LEFT
SENSOR DAYS LEFT
27
To Next Page
Loading...
Need help?
General
