30
Example of Soak screen with
only minutes
Example of Soak screen with
hours included
Station 10 cycle running
NOTE: When changing the stations, if a
station without a Cycle time is encountered,
the screen will revert back to the Cycle
time. Move to the next station with a Cycle
Time and press the button to return.
NOTE: The Soak menu cannot be accessed
without a programmed Cycle time.
NOTE: Before hour, only minutes are
displayed (e.g. ). At hour or above, the
display will change to include the hour digit
(e.g. : and :).
Cycle and Soak Situations:
Station 1 requires 20 minutes of watering, but aer 5 minutes,
runo occurs. However, aer 10 minutes all the water is absorbed.
The solution would be to program
20 minutes for the station run time,
5 minutes for the Cycle time, and 10
minutes for the Soak time.
The soak time is a minimum amount.
The soak time may be longer amount
depending on the remaining run times.
Setting the Soak Time:
To access the other stations, press the or button.
HIDDEN FEATURES CONTINUED
Accessing the Soak Menu:
Once the desired Cycle times for each station have been
programmed, the Cycle time can be accessed by pressing the
button.
The station will remain the same as was previously displayed under
the Cycle time (i.e. if station is displayed in the Cycle menu then
Station will be displayed upon pressing the
button).
Once the desired station is displayed, the user can use
the
or button to increase or decrease the Soak time.
The user can set the Soak time from minute to hours
in - minute increments.
To Next Page
Loading...
Need help?
General
