Why does my Hunter Control Panel keep watering continuously?
The Hunter Control Panel might be continuously watering because too many start times have been programmed. Only one start time is necessary to activate a program. Refer to "Setting the Program Start Time(s)" on page 11.
What to do if automatic irrigation does not start at the start time on my Hunter Control Panel?
If automatic irrigation doesn't start at the set time and the controller isn't in System Off mode, check the following: 1. Ensure the AM/PM setting for the time of day is correct. 2. Verify the AM/PM setting for the start time is correct. 3. Make sure the start time is enabled and not set to Off. 4. Replace dead batteries. 5. Check the AC power connections if you're using a transformer.
General| Voltage | 24 VAC |
|---|---|
| Display | LCD |
| Start Times per Program | 4 start times per program |
| Enclosure | Weather-resistant |
| Cycle and Soak | Yes |
| Manual Watering | Yes |
| Zones | Up to 8 |
| Battery Backup | Yes |
| Weather Adjustment | Yes |
To Next Page
