HunterDouglas PowerView User Manual

INSTALLATION
12
Fascia Shades
■
Assemble the two end brackets and
the fascia panel.
➤
Place the top of the fascia panel into the top
indention of the brackets. Rotate the panel
down and snap it into place.
IMPORTANT: Check that the outer surfaces of the brackets are flush with the ends of
the panel.
■
Center the bracket and panel assembly over the window at the desired height.
➤
Use a level against the bottom edge to make sure the assembly is level. Inside mounts
may require a shim between the brackets and the mountingsurface.
➤
For Outside Mount. Use a pencil to mark the bottom and outside edges of the
brackets on the mountingsurface.
➤
For Inside Mount. Use a pencil to mark the outside edges of the brackets on the
mountingsurface.
■
Remove the assembly from the window.
■
Remove the brackets from the fascia panel.
■
Outside Mount. Use your marks to position each bracket and mark each of the
screw holes.
➤
A minimum 4
1
⁄ 8 " flat vertical surface is required to mount the brackets.
➤
The top of the installation brackets should be at the desired height. Use your marks to
position each bracket and mark the screw holes.
IMPORTANT: The brackets should be level and aligned.
Fascia
Panel

HunterDouglas PowerView Specifications

General

Power Source	Battery
Type	Remote Control
Technology	Radio Frequency (RF)
Battery Type	CR2032
Compatibility	Hunter Douglas motorized shades and blinds
Connectivity	RF
Buttons	Multiple
Dimensions	Varies by model
Weight	Varies by model