HunterLab ColorFlex EZ - Color Index; CMC;Shade Sort

ColorFlex EZ User’s Manual Version 2.2
25
• Color Index
Choose the color index to be used. Use the DOWN arrow button to move down to
the Color Index parameter. Then scroll through the choices using the right arrow
button. Some indices may not display until both a standard and a sample are read.
Figure 35. Color Index
• CMC/Shade Sort
The CMC/Shade Sort parameter applies only if the color index chosen is dEc or SSN.
Use the DOWN arrow button to move down to the CMC/Shade Sort parameter, then
press the RIGHT arrow button to obtain the CMC/Shade Sort screen.
Figure 36. CMC Shade Sort
As shown on the button pad map at the bottom of the screen, use the UP and
DOWN arrow buttons to scroll up (+) and down (-) through the numbers for the digit
that is currently highlighted. Press the RIGHT arrow button to move to the next digit
in the value and then to move from the commercial factor to the l:c ratio and then
to the Shade Blocks. Press the LEFT arrow button when the needed values have
been entered.
Press the LEFT arrow button (Back) twice to return to the Product Setup screen.
Figure 37. CMC Parameters