ColorFlex EZ User’s Manual Version 2.2
41
CHAPTER SIX
Reading, Storing and Printing Data
Reading with Datalog
The ColorFlex EZ can manually or automatically save measurements to the Datalog on a USB
flash drive in CSV (.csv) or ASCII (.dtg) format. The precision is 3 decimal places for colorimetric
data, 5 for chromaticity values and 4 for spectral data. Once saved to the USB, it can then be
read directly into Excel or EasyMatch QC for custom reporting.
Reading with Averaging
Complete the following steps to take and average multiple readings using the ColorFlex EZ:
Note: These instructions apply when Average in the product setup is set to a
value other than OFF.
1. Select READ from the ColorFlex EZ’s main menu. Move the cursor highlight to its
position using the UP and DOWN arrow buttons and then press the GO button.
Figure 60. Select Read
2. The first Reading screen appears; select the setup to use. To read using the last
product setup that was used, press NO (down arrow) and skip to Step 4. To select
the setup from a list of setups, press YES (up arrow). The Select setup screen
appears.
Figure 61. Choose to Select the Setup
To Next Page
Loading...
