HUSABERG Edition 2004 - MAINTENANCE WORK ON CHASSIS AND ENGINE; CHECKING AND ADJUSTING THE STEERING HEAD BEARING *

- 29 -
ENGLISH
PERIODIC MAINTENANCE SCHEDULE 2004
NOTE: IF THE INSPECTION ESTABLISHES THAT PERMISSIBLE TOLERANCES ARE EXCEEDED, THE RESPECTIVE
COMPONENTS MUST BE REPLACED.
RECOMMENDED INSPECTION OF THE HUSABERG - ENGINES
USED FOR ENDURO COMPETITIONS BY YOUR
HUSABERG WORKSHOP
(ADDITIONAL ORDER FOR THE HUSABERG WORKSHOP)
a 100 liter fuel consumption is equivalent to approx. 15 operating hours
Check the clutch disks for wear ●● ●●●●●
Check the length of the clutch springs ●●●●●●
Check the cylinder and piston for wear ●●●
Check the groove on the piston pin retainer for wear (visual check) ●●●
Check the camshaft for wear (visual check) ●●●
Check the camshaft bearings ●●●
Check the length of the valve springs ●●●
Check the spring cap for wear ●●●
Check the eccentricity of the valve disk ●●●
Check the valve guides for wear ●●●
Check the radial clearance of the rocker arm rollers ●●●
Check the elongation of the timing chain ●●●
Check the chain tensioner tooting for damage (visual check) ●●●●●●
Check the eccentricity of the crankshaft journal ●●●
Replace the conrod bearings ●●●
Check piston pin bearing ●●●
Replace the balancer shaft bearings ●●●
Replace the crankshaft main bearings ●●●
Check the entire transmission including the roller and bearings for wear ●●●
30 hours
200 liter
45 hours
300 liter
60 hours
400 liter
90 hours
600 liter
120 hours
800 liter
135 hours
900 liter
15 hours
100 liter