•
Demo
: Demo mode is used for installations in shops
or exhibitions. The blade disc does not rotate and
the product alternates between short periods of
operation, docking and charging. Demo mode can
be enabled and disabled in Autocheck or in the
Tools menu.
WARNING: The blades must not be
installed when the product operates for
demonstration in public areas such as
shops and exhibitions.
•
Installation lock
: If the installation settings lock is
activated, it is not possible to change any settings in
the
Installation
menu.
Note: The installation settings lock must be
deactivated to be able to change any of the
installation settings in the main menu.
•
Temporary disable charging protection:
For safety
reasons the product is set to not charge if the
charging current is too low. Use this function
to temporary remove the protection. The product
charges with a lower current than it is specified for
the product.
4.3.6 Tools - Calibrate
The
Tools - Calibrate
menu shows:
•
Guide calibration
: The guide wire is calibrated
automatically during the first start-up sequence. A
manual calibration may however be necessary, if for
example the charging station installation is changed.
Place the product in the charging station and start
the calibration.
•
Tilt sensor calibration
: If the product does not
operates as expected in slopes it might help to
calibrate the tilt sensor. Place the product on a
horizontal surface and start the calibration.
4.4 Quick info (Limited Tools menu)
The
Quick info
menu is a limited
Tools menu
.
When the start page or the main menu is displayed:
1. Push and hold down the Menu button for 2 seconds
to access the
Quick info
menu.
4.4.1 Quick info - Info
The
Quick info - Info
menu has the same sub-menus as
in
Tools
, except for the sub-menu
Motors
. Refer to
Tools
menu (Expert mode) on page 8
.
4.4.2 Quick info - History
The
Quick info - History
menu has 2 sections:
Messages
and
Search times
.
The
History - Messages
menu shows:
•
Fault messages
: The 50 last fault messages
•
Info messages
: The 50 last information messages.
The
History - Search times
menu show the same sub-
menus as in
Tools - History, total - Search times
. Refer
to
Tools - History, total on page 9
.
4.4.3 Quick info - Advanced
The
Quick info - Advanced
menu shows the
Calibrate
menu. It has the same sub-menus as in
Tools -
Calibrate
. Refer to
Tools - Calibrate on page 11
.
1413 - 003 - 17.01.2022 Special menus - 11
To Next Page
Loading...
