4 Special menus
4.1 Tools menu overview
Tools
Info
History, total History, trip Test Special settings Calibrate
Motors User
interface
Guide
calibration
Tilt sensor
calibration
Wheel
motor
Blade
motor
Keypad Display
Key data
Key data Override
loop
detection
Demo Installation
lock
General Battery Loop Sensors Motors
Search
times
Mow
times
Battery
capacity
Reset trip
values
Temporary
disable
charging
protection
4.2 Quick info overview
Quick info
Info History Advanced
Messages
Calibrate
General Battery Loop Sensors
Search
times
4.3 Tools menu (Expert mode)
The
Tools
menu is an expert view, where additional
information and special settings are available.
When the main menu is displayed:
1. Push and hold down the arrow left key and arrow
right key for 2 seconds to access the
Tools menu
.
For more information about the product's display menus,
refer to the chapter about the Menu structure in the
Operator's manual.
WARNING: Do not return the product to the
customer with an activated
Tools menu
. Always
switch off the product with the ON/OFF button
so that the main menu is reset to normal mode.
4.3.1 Tools - Info
The
Info
menu shows the status of the product's
subsystems.
4.3.1.1 Tools - Info - General
The Tools - Info - General
menu has 2 sections:
SW
and
Prod
.
The
Info - General - SW
menu shows:
•
Article number
for software package.
•
Main
: The version of the MSW (Main Software)
program (also called the main program).
•
HMI
: The version of the HMI (Human Machine
Interface) program.
•
SUB
: The version of the SSW (Subdevice Software)
program.
•
COM
: The version of the Communication Board
program.
•
RADIO
: The version of the radio module program.
8 - Special menus 1413 - 003 - 17.01.2022
To Next Page
Loading...
