6.3 The lower chassis
The lower chassis is structured mechanically around the
following modules:
1. Lower chassis
2. Rear housing module
3. Rear wheel / Rear wheels (only for Flymo
®
and
Husqvarna
®
)
4. Front wheels
Note: There are 2 sealing strips between the upper and
lower chassis. Always replace the sealing strips when
the product is opened.
6.4 The cutting system
The cutting system is structured mechanically around
the following modules:
1. Cutting module
2. Guard
3. Blade disc
6.5 To mount screws
It is important to mount the screws correctly. Incorrect
mounted screws may harm the product. The screw
dimension is Torx 20 when there is no other information.
Note: Read the section about how to mount screws in
plastic before starting any maintenance. Refer to
To
mount screws in plastic on page 29
.
Note: Always use the recommended torque to mount the
screws. Refer to
Screw fasteners on page 32
.
6.6 To disassemble the body system
CAUTION: Clean grass and dirt from the
product before you disassemble it.
Note: This section describes how to disassemble all
parts of the body. For service or changing of spare parts
all steps may not be needed.
1. Switch off the product with the ON/OFF button. The
product is disabled when the indicator lamp is not lit.
2.
a) For GARDENA
®
, Flymo
®
and Husqvarna
®
the
top cover is attached to the body by clips. Pull
the top cover up clockwise by hand and remove
it.
b) For McCULLOCH
®
the top cover is attached by
2 screws into the body. Loosen the 2 screws,
(Torx 20), and remove it.
16 - Repair instructions 1413 - 003 - 17.01.2022
To Next Page
Loading...
