9. Continue with the remaining positions while holding
the body up.
10. Lift up and remove the body.
11.
a) Only for McCULLOCH
®
. The bumper rear is
attached to the body with clips. Push the clips
with a screwdriver and loosen it all the way
around.
b) Only for Husqvarna
®
. The bumper rear and
bumper front are attached to the body with
screws. Loosen the 8 screws (Torx 20) and
remove the bumpers.
6.7 To disassemble the upper chassis
Note: This section describes how to disassemble all
parts of the upper chassis. For service or to replace
spare parts all steps may not be needed.
1. Disassemble the body system. Refer to
To
disassemble the body system on page 16
.
2. Pull up the knob of the cutting height adjustment.
3. Push the clips inwards to remove the STOP button.
4. Lift up the STOP button.
18 - Repair instructions 1413 - 003 - 17.01.2022
To Next Page
Loading...
