Message Cause Action
Upside down
The product is leaning too much or has
turned over.
Turn the product the right way up.
Mower tilted
The product is tilted more than the
maximum angle.
Move the product to a flat area.
Needs manual
charging
The product is set to the
Secondary
area
operating mode.
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Lifted
The lift sensor is engaged because the
product hit an object or/and is blocked.
Free the product. If the problem stays,
speak to your approved servicing deal-
er.
Collision sensor
problem, front/rear
The body of the product can not move
freely around its chassis.
Remove dirt or objects between the
chassis and the body to make sure that
the body can move freely around the
chassis.
The product has become stuck. Free the product and rectify the reason.
Wheel motor
blocked right/left
Grass or other object is wrapped
around the drive wheel.
Clean the wheels and around the
wheels.
Alarm! Mower
switched off
The alarm was activated because the
product was switched OFF.
Adjust the mower security settings in
the
Security
menu. Refer to
Security
(Bluetooth
®
only) on page 37
.
Alarm! Mower
stopped
The alarm was activated because the
product was stopped.
Alarm! Mower lif-
ted
The alarm was activated because the
product was lifted.
Alarm! Mower til-
ted
The alarm was activated because the
product was tilted.
The product is tilted more than the
maximum angle.
Move the product to a flat area.
1460 - 002 - 06.04.2020 Troubleshooting - 49
To Next Page
Loading...
