36 – English
Fuel system
3. Loosen the front mounting (3) from the tank.
Keep the washers safe for retting.
4. Loosen the rear mounting (4), move the
mounting away and lift away the tank.
5. Tightening torque, mountings 12 Nm.
6. Top up with fuel if necessary, start the machine
and check for leakage.
7. Bleed the fuel system if necessary.
Bleeding the Fuel System
Tools Dimension Quantity
Combination
wrench
10 mm 1
The fuel system may need bleeding if
• the fuel filter and fuel lines have been removed,
• the fuel tank has been emptied,
• the machine has not been used for a long period.
Facilitate bleeding by pumping using a hand pump.
Remove the fuel tank filler cap and check the return
fuel to the tank. When bubble free fuel flows to the
tank, the engine can be started.
Carry out full bleeding as follows:
1. Make sure the stop valve (2) is open.
See illustration.
2. Loosen the air screw (3) on the fuel lter (1)
at least 1/2 turn.
3. Pump using the fuel pump's hand pump (4)
until clean fuel, without air bubbles, exits the
air screw.
4. Tighten the air screw moderately.
5. Rotate the engine with the starter motor for
a maximum of 15 seconds. Wait 30 seconds
before the next start attempt.
2
3
1
4
8095-266
1. Fuel filter
2. Stop valve (open)
3. Venting screw
4. Hand pump
To Next Page
Loading...
