English – 39
Electrical System
Circuit Board, Changing
IMPORTANT!
It is important to check the circuit outside of
the circuit board rst, to ensure this is correct,
before replacing the circuit board. This is
partly due to cost, but also so that no external
fault can damage the new circuit board.
Tools Dimension Quantity
Round nose
pliers, bent
1
Screwdriver, PZ 1
Torx T20 1
Torx T30 1
1. Loosen the negative cable from the battery.
2. Dismantle the side cover.
3. Remove the cover over the distribution box.
4. Check the marking on the cable connections
and note the position of the cable harnesses.
Some connections have markings on the
cables. Supplement if necessary when the
connections have been disconnected.
Contacts are color coded and the corresponding
color is given on the circuit board.
8095-314
3
9
10
11
5
6
7
4
2
3
1
8
1. Cable with connection
2. Cable with connections
3. Cable with connections
4. Cable with connections
5. Cable with connections
6. Starter module
7. Screws for circuit board
8. Circuit boards
9. Cable with connection
10. Cable with connection
11. Cable with connection
5. Loosen all connections from the circuit board.
Use bent round nosed pliers to press in the
plastic catches holding the connections.
To Next Page
Loading...
