Husqvarna P 525D - Safe Operation and Slope Handling; Environmental and Personal Safety

8 – English
Chassis
Repair Instructions
CHASSIS
Removing Driver's Seat
WARNING!
The seat is heavy and can fall if let
go. Secure it from falling. Risk of
personal injury.
Tools Dimension Quantity
Combination
wrench
13 mm
1
Socket wrench
13 mm
1
Wire cutters 1
1. Tilt the seat back.
2. Cut the cable ties and loosen the connection (1).
3. Secure the seat from falling back when the stay
(2) and hinge (4) are loosened.
4. Unhook the stay (2) from the frame recess rst,
then from the seat.
5. Loosen the two hinges (4) and lift away
the seat.
6. Reassemble the seat in the reverse order.
7. Check the safety breaker after assembly.
See the Operator's Manual.
4
5
1
2
3
8095-255
1. Connection with cable ties
2. Stay
3. Notch
4. Hinge
5. Lock mechanism
Changing Throttle Cable
Tools Dimension Quantity
Socket wrench 10 mm 1
Combination
wrench
13 mm 1
Torx T30 1
Snipe nose pliers 1
1. Pull back on the throttle control (1) to its end
position.
2. Remove the side cover.
3. Open the engine cover.
4. Loosen one or both lock nuts (6) on the throttle
cable fastening on the engine control arm.
Remove the air cleaner if necessary to make
room.
5. Pull the throttle cable (4) through to the right
side. Note the route of the cable through the
machine.
6. Press the throttle cable (4) out of the cable
holder (5).
7. If it is difcult to access, loosen the throttle
control. First remove the plastic knob on the
control bracket. Then unscrew the bracket.
2
3
6
7
1
4
5
8095-233
1. Throttle control
2. Control bracket
3. Screw
4. Throttle control cable
5. Cable holder
6. Lock nuts
7. Control arm
8. Assemble in the reverse order.
9. Check the operation of the throttle control. See
Checking the Engine Speed.