Husqvarna P 525D - Filter Holder, Changing

English – 55
Hydraulic System
Filter Holder, Changing
Tools Dimension Quantity
Allen Key 8 mm 1
Combination
wrench
17 mm 2
Combination
wrench
22 mm 2
Combination
wrench
27 mm 1
Combination
wrench
32 mm 1
Socket wrench 13 mm 1
Socket wrench 22 mm 1
Socket wrench 27 mm 1
Torque wrench 1
Dismantling
1. Fold up the seat.
2. Dismantle the protective plate under the seat.
3. Loosen the hydraulic hoses and plug the lines
and connections.
4. Dismantle the hydraulic pipes at both ends and
plug the lines and connections.
5. Dismantle the two retaining screws (1) holding
the lter holder (3) and remove the holder.
6. If the lter holder is being changed, the adapters
must be dismantled and reused after inspection.
7. Clean thoroughly as instructed.
IMPORTANT!
If there is not enough room, the adapter
can be torque tightened to the lter holder
after the hose has been torque tightened
to the adapter. In this way, the adapter can
be turned into position for better access to
torque tighten the hose.
4
1
2
3
5
8095-292
1. Filter holder retaining
screw
2. Connections
3. Filter holder
4. Hydraulic oil filter
5. Connection 60 Nm
Assembling
1. Install in reverse order.
2. If the adapters are to be retted, they must be
torque tightened to 50 Nm except pos. 5 in the
illustration, which is tightened to 60 Nm.
3. Assemble the hydraulic hoses and torque
tighten as instructed.
4. Check the oil level in the hydraulic system and
top up if necessary.
5. Start the machine and check for any leakage.
Fill with oil if necessary.