Husqvarna P 525D - Cutting Deck; Bearing Housing Blade Bearing, Changing

English – 61
Cutting deck
CUTTING DECK
Bearing Housing Blade Bearing, Changing
Tools Dimension Quantity
Torx T30 1
Socket wrench 24 mm 1
Socket wrench 18 mm 1
Socket wrench 13 mm 1
Breaker 1
Torque wrench 1
Combination
wrench
7 mm 1
Dismantling
1. Disconnect the cutting deck.
2. Remove the protective covers (8) over the belt.
3. Prise off the belt from the pulley in question.
4. Assemble the cutting deck and place in service
position.
4
1
5
3
2
6
7
4
8
9
1. Cotter pin
2. Link joint
3. Cutting deck mounting
4. Cutting height setting
5. Propeller shaft with
quick couplings
6. Attachment point for
service position
7. Service strut
8. Protective cover
9. Gear
5. Remove the grease nipple (4).
6. Lock the blade with a wooden block.
7. Loosen the anged nut (1) on the belt pulley
about 1.5 turns.
8. Put a 24 mm socket with extender on the
loosened nut.
9. Tap the extender so that the belt pulley (2)
comes free from the blade mounting. Heat if
necessary.
10. Remove the anged nut and the belt pulley.
11. Remove the at key (3) and dust shield (5).
8095-340
3
2
1
5
4
1. Flange nut
2. Belt pulley
3. Flat key
4. Grease nipple
5. Dust shield
12. Remove the four nuts (1) with screws holding
the bearing housing (2).
13. Remove the bearing housing.
14. Put the blade in a vice.
15. Dismantle the screw (4) for the blade. Remove
the screw and the blade washer (3) with blade.
IMPORTANT!
The blade washer is convex. Always turn the
convex side against the screw head.
Assembling
1. Clean the contact surfaces on the blade, blade
washer, bearing housing and belt pulley.
2. Assemble in the reverse order.
8095-347
1
2
3
4
1. Nut
2. Bearing housing
3. Blade washer
4. Screw