Husqvarna TE 300i User Manual

17 TUNING THE ENGINE
125
V00967-10
Main work
– Move the handlebar to the straight-ahead position.
–
Push back sleeve
1
.
–
Loosen nut
2
.
–
Turn adjusting screw
3
in as far as possible.
–
Loosen nut
4
.
–
Turn adjusting screw
5
in as far as possible.
–
Turn adjusting screw
3
so that there is play in the throttle
cable at the throttle grip.
Guideline
Play in throttle cable 3 … 5 mm (0.12 … 0.2 in)
–
Unscrew the adjusting screw
5
until the smooth operation
or play in throttle cable is worsened.
–
Turn the adjusting screw
5
approx. two turns further.
–
Tighten nut
4
.
–
Tighten nut
2
.
–
Slide on sleeve
1
.
– Check the throttle grip for smooth operation.
Finishing work
– Check the play in the throttle cable. ( p. 124)
17.3 Setting the characteristic map of the throttle response
Info
On the throttle grip, the characteristic map of the throttle response is changed by changing the guide
plate.
A guide plate with a different characteristic map is supplied.
V00968-10
Main work
–
Push back sleeve
1
.
–
Remove screws
2
and half-shells
3
.
– Detach the throttle cables and take off the grip tube.

Husqvarna TE 300i Specifications

General

Engine Type	Single cylinder, 2-stroke
Displacement	293.2 cc
Bore x Stroke	72 mm x 72 mm
Fuel System	Electronic Fuel Injection
Starter	Electric starter
Transmission	6-speed
Cooling System	Liquid cooled
Front Suspension	WP XPLOR-USD, Ø 48 mm
Front Brake	260 mm disc
Rear Brake	220 mm disc
Fuel Capacity	9 L
Seat Height	950 mm
Ground Clearance	370 mm