Husqvarna TE 300i User Manual

11 TUNING THE CHASSIS
52
11.12 Adjusting the compression damping of the fork
Info
The hydraulic compression damping determines the fork suspension behavior.
K00929-10
–
Turn white adjusting screw
1
clockwise as far as it will go.
Info
Adjusting screw
1
is located at the upper end of the
left fork leg.
The compression damping is located in left fork
leg COM (white adjusting screw). The rebound
damping is located in right fork leg REB (red adjusting
screw).
– Turn counterclockwise by the number of clicks correspond-
ing to the fork type.
Guideline
Compression damping
Comfort 18 clicks
Standard 15 clicks
Sport 12 clicks
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
11.13 Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
K00930-10
–
Turn red adjusting screw
1
clockwise as far as it will go.
Info
Adjusting screw
1
is located at the upper end of the
right fork leg.
The compression damping is located in left fork
leg COM (white adjusting screw). The rebound
damping is located in right fork leg REB (red adjusting
screw).
– Turn counterclockwise by the number of clicks correspond-
ing to the fork type.

Husqvarna TE 300i Specifications

General

Engine Type	Single cylinder, 2-stroke
Displacement	293.2 cc
Bore x Stroke	72 mm x 72 mm
Fuel System	Electronic Fuel Injection
Starter	Electric starter
Transmission	6-speed
Cooling System	Liquid cooled
Front Suspension	WP XPLOR-USD, Ø 48 mm
Front Brake	260 mm disc
Rear Brake	220 mm disc
Fuel Capacity	9 L
Seat Height	950 mm
Ground Clearance	370 mm