Husqvarna TE 300i User Manual

12 SERVICE WORK ON THE CHASSIS
81
12.37 Checking the chain, rear sprocket, engine sprocket, and chain guide
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 56)
400227-01
Main work
– Shift the transmission to idle.
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
– Change the drivetrain kit.
Info
The engine sprocket, rear sprocket, and chain
should always be replaced together.
400987-10
–
Pull at the top part of the chain with the specified weight
A
.
Guideline
Weight, chain wear mea-
surement
10 … 15 kg (22 … 33 lb.)
–
Measure distance
B
of 18 chain rollers in the lower chain
section.
Info
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Maximum distance
B
at
the longest chain section
272 mm (10.71 in)
»
If distance
B
is greater than the specified measurement:
– Change the drivetrain kit.
Info
When the chain is replaced, the rear sprocket
and engine sprocket should also be changed.
New chains wear out faster on old, worn
sprockets.

Husqvarna TE 300i Specifications

General

Engine Type	Single cylinder, 2-stroke
Displacement	293.2 cc
Bore x Stroke	72 mm x 72 mm
Fuel System	Electronic Fuel Injection
Starter	Electric starter
Transmission	6-speed
Cooling System	Liquid cooled
Front Suspension	WP XPLOR-USD, Ø 48 mm
Front Brake	260 mm disc
Rear Brake	220 mm disc
Fuel Capacity	9 L
Seat Height	950 mm
Ground Clearance	370 mm