Husqvarna TE 300i User Manual

12 SERVICE WORK ON THE CHASSIS
87
V00916-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 ( p. 152)
–
On the slave cylinder, remove bleeder screw
5
and mount
bleeding syringe
4
.
V00951-10
– Now inject the fluid into the system until it emerges from drill
hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.45 Removing the engine guard
H01655-01
–
Remove screws
1
and engine guard.

Husqvarna TE 300i Specifications

General

Engine Type	Single cylinder, 2-stroke
Displacement	293.2 cc
Bore x Stroke	72 mm x 72 mm
Fuel System	Electronic Fuel Injection
Starter	Electric starter
Transmission	6-speed
Cooling System	Liquid cooled
Front Suspension	WP XPLOR-USD, Ø 48 mm
Front Brake	260 mm disc
Rear Brake	220 mm disc
Fuel Capacity	9 L
Seat Height	950 mm
Ground Clearance	370 mm