3.4
DRIVE WHEEL TRACKING (Refer to gearbox illustration)
Release the blade tension before adjusting. Loosening bolts “A” and turning in set screws “C” by equal amounts will move
the blade OFF the wheel. Loosening bolts “B” and turning in set screws “D” by equal amounts will move the blade ON to
the wheel. After each “C” or “D” set screw adjustment, tighten bolts “A” or “B”, turn the blade tension switch to “+/RUN”,
and then run the blade for a moment to recheck the tracking.
IDLER WHEEL ADJUSTMENT
The tracking is adjusted by regulating the “push” set screws and the “pull” hex bolts. Before making any adjustments, bolts
“A & B” should be loosened but remain snug. This will allow easy movement for the slide assembly. Loosening bolts “A”
and turning in set screws “C” by equal amounts will move the blade OFF the wheel. Loosening bolts “B” and turning in set
screws “D” by equal amounts will move the blade ON to the wheel. After each “C” and “D” adjustment, tighten bolts “A”
and “B”, run the blade and then check the tracking.
D B D
D B D
C A C
C A C
To Next Page
Loading...
