Hyd-Mech S20DSP - Default Chapter; Table of Contents

Introduction and technical specifications 1---1......................
Foreword 1---1..........................................................
Machine presentation 1---1...............................................
Machine specification 1--- 2...............................................
Dimensions 1---4........................................................
F u n c t i o n a l p a r t s 2 --- 1............................................
S20DSP model 2---1.....................................................
Cutting head 2---2.......................................................
Vice 2 --- 3..............................................................
C o n t r o l Pa n e l 2 --- 3......................................................
Tu r n t a b l e 2 --- 4..........................................................
F i x e d p l a t f o r m 2 --- 4.....................................................
M o t i o n --- v a r i a t o r --- r e d u c e r u n i t 2 --- 5.......................................
Base 2 --- 6..............................................................
Safety and accident prevention 3---1................................
U s e o f t h e m a c h i n e 3 --- 1.................................................
General recommendations 3---2...........................................
Recommendations to the operator 3---3....................................
Machine safety devices 3---5..............................................
Reference standards 3---5................................................
Protection against acci dental contact with the blade 3---6......................
Electrical equipment 3---6................................................
Emergency devices 3---7..................................................
Noise level of the machine 3---8...........................................
Noise level measurement 3---8............................................
Noise level values 3---8...................................................
Vibration emission 3---9..................................................
Electromagnetic compatibility 3---9........................................
Machine installation 4---1........................................
Packaging and storage 4---1...............................................
Anchoring the machine 4---4..............................................
Minimum requirements 4---4..............................................
C h e c k l i s t 4 --- 5..........................................................
Connection to the power supply 4---6.......................................
Description of machine operation 5---1.............................
Control panel description 5---1............................................
Basic instructions for carrying out a cutting operation cycle 5---3................
Manoeuvring the cutting head 5---3........................................
Clamping the work piece in the vice 5---3...................................
Rapid vice positioning 5---4...............................................
R a p i d v i c e t r a n s l a t i o n 5 --- 6...............................................
Wi d t h o f c u t 5 --- 6.......................................................
Preliminary check list for cutting operation 5---7.............................
Semi---automatic operating cycle 5---7......................................
Execution of inclined cuts 5---10............................................
Loading side rollerway position 5---10.......................................
Angled cuts 45˚ to the left 5---11...........................................
Angled cuts 60˚ to the left 5---12...........................................
Angled cuts 45˚ to the right 5---14..........................................
Angled cuts 60˚ to the right 5---15..........................................