5--10
38
Use and maintenance manual S20DSP
Execution of inclined cuts
It is possible to perform inclined cuts with angles from 60˚ left and 60˚ right. The
rotating platform has pre---set reference strokes for the fast execution of cuts at
0˚,45˚,60˚ right, and 45˚,60˚ left.
Inanycaseitmustbepointedoutthatthebarsupportrollerway,locatedonthe
loading side of the machine (to the left of the cutting table) has two pre---set
positions, one for straight cuts or cuts with an inclination of up to 30° (left or
right), the other for cuts with an inclination of 60° right.
Loading side rollerway position
For 0° or 30° left/right cuts check that the rollerway is positioned as shown in the
drawing below:
For 30˚ to 60° right cuts check that the rollerway is positioned as shown in the
drawing below:
To Next Page
Loading...