5--9
37
Description of machine operation
" Fully close the head lowering adjuster, on the right side of the control con-
sole.
" Correctly position the workpiece in the vice and calculate the length of cuts
( u s i n g t h e c u t --- t o --- s i z e r o d ) .
" Opentheviceusingtherelativebuttonandmanuallymovethevicetowards
the material, leaving a minimum distance of 2÷3 mm. (as illustrated in the
Manual cycle).
23mm
" Start the cutting cycle pressing the cycle start key.
" After you have given the START command, the blade starts to rotate, the vice
clamps the workpiece and the coolant spray is activated. The cutting head will
remain in the start position until the head descent regulator located on the
front right of the base is opened.
Adjust the head downstroke speed in accordance with the type of material
being cut, the blade rotation speed and the quality of finish required.
" Once the piece has been cut (FCTA position), the blade stops rotating, the
cutting head returns to the FCTI position and the vice opens. The machine is
now ready to start a new cycle.
Warning
To Next Page
Loading...
General