Hyd-Mech S20DSP - Adjustments; Displaying and Editing Set-Up Parameters

To Next Page

To Previous Page

7--1

Adjustments

This chapter describes the operations required to adjust the electronic, mechan-

ical and the hydraulic systems. By following these instructions, you can “custom-

ise” your machine to suit the type of cut required, thereby optimising cutting

times.

Displaying and editing the set--up parameters

The machine set---up parameters may be programmed directly from the control

console.

" Power up the machine at the main switch located on the left hand side.

" Press simultaneously and in sequence the keys MAC HINE PARAMETERS

and MACHINE START;