Hyd-Mech S20DSP - Page 5

Maintenance require ments 8---2...........................................
General maintenance 8---2...............................................
Daily 8 --- 2.............................................................
Weekly 8 --- 2............................................................
Monthly 8---3...........................................................
Maintenance of working parts 8---3........................................
Consumable materials 8---3...............................................
Oils for oleopneumatic circuit 8---3........................................
Oil for lubricant/coolant fluid 8---4.........................................
Cutting speed and choice of tools 9---1..............................
Cutting speed 9---1......................................................
Standard machine 9---1..................................................
Choice of blade 9---2....................................................
Saw tooth pitch 9---2.....................................................
Cutting speed and downstroke speed 9---2..................................
Ty p e s o f s w a r f : 9 --- 3.....................................................
Lubricant/coolant fluid 9---4..............................................
Blade structure 9---4.....................................................
B l a d e t y p e s 9 --- 5........................................................
C o n v e n t i o n a l r a k e 9 --- 5..................................................
Po s i t i v e r a k e 9 --- 5.......................................................
Va r i a b l e p i t c h 9 --- 5......................................................
Variable pitch blades with 0˚ cutting angle 9---6..............................
Variable pitch with positive rake (from 9 to 10 degrees) 9---6...................
Set: 9 --- 6...............................................................
Standard or splayed set 9---6..............................................
U n d u l a t e d s e t 9 --- 7......................................................
Alternating grouped sets 9---7.............................................
A l t e r n a t i n g s e t 9 --- 7.....................................................
Blade selecti on table relating to cutting speed and downstroke speed 9---8.......
Classifi cat ion of stee ls 9---9...............................................
Classification of steels 9---10...............................................
Troubleshooting 10---1............................................
Troubleshooting blade and cutting problems 10---1............................
Troubleshooting 10---7....................................................
D i a g n o s t i c s s y s t e m 1 0 --- 8..................................................
Machine alarms and emergencies 10---10.....................................