1--3
3
Introduction and technical specifications
LUBRICANT/COOLANT FLUID AND OIL
Oil for blade tensioner unit (optional) capacità Lt 8,5
Lubricant/coolant fluid (oil concentration 5---6%) capacità Lt 200
VICE
Vice max. opening mm 455
SPINDLE MOTOR
No.of poles Current (Volts) Absorption
(Amps)
Power (Kw) rpm
4 400 3,7 1,5 1410
Stator wound with enamelled copper wire, class H 200˚C.
Class F insulation (limit temperature TL 155˚C).
IP 55 protection rating (total against contact with live parts, water sprayed from all directions, with shaft oil
seal).
Conforming to CEI norms, publication: IEC 34 of 01/07/1985.
Example of class F insulation: in air --cooled machines at an ambient tempera-
ture of 40˚ C (according to CEI 2--3 and IEC 85), the allowable overtempera-
ture is 100˚ C (where 100
ٛ
C represents the allowable DT).
ELECTROPUMP MOTOR
Single phase; Frequency 50 Hz.
Voltage (Volts) Absorption
(Amps)
Power (Kw) rpm Delivery rate
lt/min
Head (mt.)
230 0,30 0,09 2800 24 1,5
400 0,18 0,09 2800 24 1,5
Protection rating IP 55.
Conforming to CEI norms, publication: IEC 34 of 01/07/1985.
CUTTING CAPACITY
Section
0˚ 330 330 450x330
45˚ a 320 300 300x300
60˚ a 210 200 200x200
45˚ ' 320 300 300x300
60˚ ' 210 200 200x200
N.B.
To Next Page
Loading...