2-5: Installation Information
SETTING UP THE GTXR +
Prior to operating the GTXR +, follow these steps:
1. Adjust the vacuum relief located on the recovery tank by capping all the vacuum
inlets. The machine should be set to 14” Hg maximum.
Setting the vacuum level higher than the recommended value can result in an
increased risk of serious component damage.
The GTXR + is shipped from the factory with antifreeze added to the solution system.
Recover this antifreeze and dispose of the recovered antifreeze as stated in the local laws
and regulations.
KEEP ANTIFREEZE OUT OF REACH OF CHILDREN AND ANIMALS. Drinking
antifreeze can cause death.
If required, dispose of antifreeze at facilities licensed to accept household
hazardous waste. If permitted, dispose of antifreeze in sanitary sewer systems.
Do not pour antifreeze into storm sewers, septic systems, or onto the ground.
Doing so causes health and environmental dangers.
Ensure the antifreeze is completely drained from the solution system. If any
antifreeze remains in the system, it could damage machine components and
damage fabric.
To Next Page
Loading...
