HydroPoint WeatherTRAK 2-Wire - Troubleshooting; Standard Power and Current Readings

WeatherTRAK 2-Wire Controller Installation Guide
33
©
2020 HydroPoint Data Systems Inc. All rights reserved. 800.362.8774 • hydropoint.com
Press . Press + or – to select the desired station, master valve, pump start or flow sensor. The screen will
look something like this:
Line 1: Screen number, time
Line 2: Screen name
Line 3: Decoder output number, On/Off, mA value per decoder.
Line 4: Voltage in line, total value in mA for all decoders