EasyManuals Logo
Home>Hypertherm>Cutter>Command THC

Hypertherm Command THC User Manual

Hypertherm Command THC
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #124 background imageLoading...
Page #124 background image
POWERMAX SETUP
CommandTHC for X-Y Table Instruction Manual 3g-5
11
Power supply interface cable
See Figure 3g-3.
Connect the interface cable to the receptacle on the back of the power supply.
Install the 2 pairs of wires of the interface cable to the plasma interface assembly as shown in
Figure 3g-3.
See applicable Powermax service manual for the interface cable part numbers and signal list.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm Command THC and is the answer not in the manual?

Hypertherm Command THC Specifications

General IconGeneral
BrandHypertherm
ModelCommand THC
CategoryCutter
LanguageEnglish

Related product manuals