Hypertherm Command THC User Manual

APPENDIX A – PARTS LIST FOR OLDER SYSTEMS
a-4 CommandTHC for X-Y Table Instruction Manual
11
Control module exterior
Index no.
Part no. Description Quantity
1 053018 Control module 1
1 002261 Enclosure: control module 1
2 129067 Heatsink assembly 1
2 004705 Heatsink 1
3 005186 Power entry module: fused filter 1
4 008971 Fuse: T, 3.15 Amp, H 250 V, 5 mm x 20 mm 2
5 *041507 PCB: control (see figure on next page) 1
6 *081029 Firmware: real-time microprocessor 1
7 *081030 Firmware: interface microprocessor 1
8 041511 PCB: motor drive (see figure on next page) 1
9 229070 Power source: 130W (see figure on next page) 1
10 123254 Cable: 50C ribbon (not shown) 1
11 129066 Wiring harness (not shown) 1
3
1
2
4
THC control module
2
* These items can only be used with the older plasma interface assembly (128048). See previous page.

Hypertherm Command THC Specifications

General

Brand	Hypertherm
Model	Command THC
Category	Cutter
Language	English