HT4400 SETUP
3h-6 CommandTHC for X-Y Table Instruction Manual
5
Plasma interface PC board connection
See Figure 3h-3.
Install the 37-pin connector to the plasma interface PC board.
Install the J2 and J3 connectors to the plasma interface PC board.
NOTE: Wire No. 42 and 45 are secured to the 37-pin connector cable inside the power supply.
Remove the wires and install as follows.
Connect wire No. 42 to the plasma interface board J5-2 terminal labeled ELECTRODE.
Connect wire No. 45 to the plasma interface board J5-3 terminal labeled WORK.
Connect the other end of wire No. 42 to the top bus bar.
Connect the other end of wire No. 45 to the bottom bus bar.
Secure all wires and cables as required.
To Next Page
Loading...
