Hypertherm Command THC User Manual

11
Command THC for X-Y Table Instruction Manual b-1
Under certain lighting conditions, or in cold temperatures, it may be necessary to adjust the contrast of the pendant
display for better visibility. The menu for this parameter also contains other parameters that are critical for the proper
operation of the THC. The only parameter that should be adjusted is the VIEWING ANGLE. The default settings
are listed in case it becomes necessary to reset other parameters.
The following keys on the keypad represent the function keys (F1 – F5)
Appendix B
PENDANT CONTRAST ADJUSTMENT PROCEDURE
= not used
F1 F5F4F3F2
F1 = MAINT/MODE
F2 = AUTO/MAN.
F3 = Blank key to the right of AUTO/MAN.
F4 = RETR. MID/FULL
F5 = IHS TEST/RUN
Procedure
1. Press the SHIFT key + the MAINT/MODE key + the blank key next to the shift key at the
same time. The following options will APPEAR on the change settings menu:
F1 – CHANGE THE SETTINGS
F2 – NEXT OPTION
F3 – PREVIOUS OPTIONS
F4 – QUIT WITHOUT SAVING
F5 – SAVE & EXIT

Hypertherm Command THC Specifications

General

Brand	Hypertherm
Model	Command THC
Category	Cutter
Language	English