5
HPR130 Manual Gas Instruction Manual b-3
SECTION 4 – FIRST AID MEASURES
MSDS
PAGE 2 OF 4
PRODUCT
Hypertherm Torch Coolant
CODE
INGESTION
Never give anything by mouth to an unconscious person. Give several glasses of water. If
vomiting is not spontaneous, induce vomiting. Keep airway clear. Get medical attention.
If affected, remove from exposure. Restore breathing. Keep warm and quiet. Get medical
attention.
Immediately flush eye with cool running water. Remove contact lenses if applicable.
Continue flushing with water for at least 15 minutes. Get immediate medical attention.
Wash with soap and water. If irritation develops or persists, get medical attention.
INHALATION
EYE CONTACT
SKIN CONTACT
Treatment based on judgment of the physician in response to reactions of the patient.
NOTE TO
PHYSICIAN
SECTION 5 – FIRE FIGHTING MEASURES
SECTION 6 – ACCIDENTAL RELEASE MEASURES
SECTION 7 – HANDLING AND STORAGE
FLASH POINT / METHOD
None to boiling.
FLAMMABLE
LIMITS
Not Established
EXTINGUISHING MEDIA
Product is an aqueous solution. Use Carbon Dioxide, Dry Chemical, Foam.
Full protective equipment including self-contained breathing apparatus
should be used. During emergency conditions overexposure to
decomposition products may cause a health hazard. Symptoms may not be
immediately apparent. Get medical attention.
Water base solution.
SPECIAL FIRE FIGHTING
PROCEDURES
FIRE AND EXPLOSION
HAZARDS
RESPONSE
TO SPILLS
Small spills: Mop up residues and place in a covered waste disposal container.
Large spills: Dike or dam spill. Pump to containers or soak up on inert absorbent. Place in
covered waste dissposal container.
HANDLING
PRECAUTIONS
Keep container in upright position. Avoid breathing or creating airborne mists. Avoid
contact with skin eyes, and clothing. Avoid inhalation of vapor or mists. DO NOT TAKE
INTERNALLY. Clean up spills immediately.
STORAGE
PRECAUTIONS
Store in a cool dry place. Keep from freezing. Keep containers tightly closed when not
in use.
To Next Page
Loading...
Need help?
General
