Hypertherm HPR130 Manual Gas - Fill the Power Supply with Coolant

INSTALLATION
3-36 HPR130 Manual Gas Instruction Manual
5
Fill the power supply with coolant
The system will take 11.4 – 15.1 liters (3 to 4 gallons) of coolant depending on the length of the torch leads and if
the system has a local or remote ignition console.
The current display shows the flow rate.
When the flow rate is constant and
greater than 0.6 gpm, release the knob.
The display will show the current again.
The pump will continue to run.
3
Add coolant to the power supply
until the tank is full and replace the
filler cap.
4
Add coolant to the power supply until
the tank is full.
1
Press and hold the current selection
knob (8) and press power switch on
the gas console. The pump will
run continuously while (8) is pressed.
2
Caution: The coolant pump will be damaged if it is run with water only. See
torch coolant requirements for proper coolant mixtures. Do not
over fill coolant tank.