OPERATION
5
4-8 HPR130 Manual Gas Instruction Manual
Cut charts
The following
Cut charts
show the consumable parts, cutting speed and the gas and torch settings required for
each process.
The numbers shown in the
Cut charts
are recommended to provide high-quality cuts with minimal dross. Because
of differences between installations and material composition, adjustments may be required to obtain desired
results.
Marking
Any of the consumable sets can also be used for marking. Marking parameters are shown at the bottom of each
cut chart. The quality of the markings will vary depending on the cut process, material type, and material thickness
combination. Marking is not possible for every combination (very thin materials). Poor quality marking or burn-
through may occur with material less than 1.5 mm (0.060" or 16 gauge).
Consumables for mirror-image cutting
See the
Parts List
section of this manual for part numbers.
To Next Page
Loading...
